Additional information
| Brand | Essom |
|---|
Bends and Fittings Friction
The equipment measures pressure drops at various flow rates when water flow through different pipe bends, and fittings. It is to be used with Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
All bends and fittings are connected in series with pressure tappings on both sides of each device. A water manometer with a vent valve and a hand air pump is connected to these tappings. A valve at the outlet is used to control outlet pressure.
TYPICAL EXPERIMENTS
- Determination of Pressure Drop across various pipes and fittings at differing flow rates.
- Estimation of Loss Coefficient (K) or various pipes, pipe fittings and valve settings
TECHNICAL DATA
| Pipe diameter (nominal) | 20 mm. | |
| Enlarged pipe diameter (nominal) | 35 mm. | |
| Bends | 90º Miter bend , 90º small radius bend , 90º large radius bend | |
| Fittings | 90º Elbow , 45º elbows , Sudden expansion , Sudden contraction | |
| Water manometer | 8 tubes x 450 mm x 1 mm graduation | |
| Software for data display and analysis by computer (separately supplied). | ||
100% Original and qualityRelated products
-
Hydraulic Studies and AccessoriesFlow Over a Notch
The apparatus is for the study of flow over a notched weir. It is to be used with Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
Three weir plates, a rectangular notch and two V notches, are provided. Characteristics of flow over the notches can be observed and coefficients of discharge can be determined. The plates are attached to the open channel of the Hydraulics Bench. Water is supplied to the channel via a discharge diffuser and passes through a stilling baffle to smooth the flow. A vernier hook and point gauge is provided to measure the height of water level in the channel.
TYPICAL EXPERIMENTS- Investigation of head against discharge
- Coefficient of discharge for notches
- Demonstration of flow over different notch weirs
TECHNICAL DATAWeir plates Rectangular notch, 60o and 90o V notches. Stainless steel vernier hook and point gauge range 0-150 mm. Software for data display and analysis by computer (separately supplied). (0 reviews) -
Hydraulic Studies and AccessoriesPipe Friction
This equipment measures pressure drop when water flows through a vertical pipe at various flow rates both laminar and turbulent. It is to be used with Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
It consists of adjustable constant head water source of removable clear acrylic cylinder for laminar flow. Turbulent flow may be achieved by directly connecting the pipe to the Hydraulics Bench water supply. A water manometer with a vent valve, a hand air pump and a differential pressure gauge are provided for measurement of pressure drop. A valve at the outlet is used to control outlet pressure.
TYPICAL EXPERIMENTS- Investigations of laminar and turbulent flows
- Demonstration and measurement in a change of the laws of resistance (friction factor) from laminar to turbulent flow
TECHNICAL DATAWater manometer 450 mm x 1 mm graduation. Differential pressure gauge 1 ea. Test section length Over 500 mm. Measuring cup 1 L. Software for data display and analysis by computer (separately supplied) (0 reviews)