Additional information
| Brand | Essom |
|---|
Shell and Tube Heat Exchanger (Transparent Casing)
The apparatus is used for studying heat transfer through a shell and tube heat exchanger under parallel or counter flow conditions.
The unit consists of a shell and tube heat exchanger, and a service module. The module comprises a hot water tank with a transfer pump and instruments for monitoring and control. Parallel and counter flow is selected by switching cold water hoses with quick coupling. The unit requires outside water supply.
Instruction manual is also included.
TYPICAL EXPERIMENTS
- Demonstration of heat transfer under parallel and counter flow.
- Determination of heat transfer coefficient.
- Effects of flow rate and temperature difference.
TECHNICAL DATA
| Construction arrangement | Stainless steel inner tubes with transparent casing (borosilicate glass) |
| Service module consisting of: | |
| – Hot water pump. | |
| – Heater | 3000 W. |
| – Flow meters |
|
| – Temperature control un . it to limit temperature of hot water to not more than 80°C | |
| Software for data display and analysis by computer (separately supplied). | |
| Power supply | 220 V, 1 Ph, 50 Hz. Other power supply is available on request. |
100% Original and qualityRelated products
-
Flow Measurement and Flow StudyGround Water Flow Apparatus
This apparatus is for studying the hydrological principles of ground water flow and application of the flow to certain engineering constructions.
The apparatus consists of a square stainless steel sand tank supported on epoxy painted steel frame. Two horizontal water inlet pipe diffusers are installed at both ends of the sand tank. Two vertical outlet wells are installed next but interior to the inlet diffusers. Both inlet and outlet are controlled by valves to produce various water flow tables and flow rates.
Nineteen tappings with special filter at the base of the tank arranged in orthogonal axes are connected to a manometer at the side of the tank to indicate ground water levels. Outside water supply in required.
Instruction manual is also included.
TYPICAL EXPERIMENTS- Hydraulic profile between inlet and outlet.
- Profile with one outlet.
- Profile with two outlets.
- Profile with concentric cove.
- Profile with square ditch.
TECHNICAL DATATank dimensions approximately 100 cm long x 50 cm wide x 30 cm deep Inlet pipes and outlet wells 2 ea. Manometer 19 tubes. Models Small square, large square, concentric cove. Software for data display and analysis by computer (separately supplied). (0 reviews) -
Hydraulic Studies and AccessoriesFlow Over a Notch
The apparatus is for the study of flow over a notched weir. It is to be used with Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
Three weir plates, a rectangular notch and two V notches, are provided. Characteristics of flow over the notches can be observed and coefficients of discharge can be determined. The plates are attached to the open channel of the Hydraulics Bench. Water is supplied to the channel via a discharge diffuser and passes through a stilling baffle to smooth the flow. A vernier hook and point gauge is provided to measure the height of water level in the channel.
TYPICAL EXPERIMENTS- Investigation of head against discharge
- Coefficient of discharge for notches
- Demonstration of flow over different notch weirs
TECHNICAL DATAWeir plates Rectangular notch, 60o and 90o V notches. Stainless steel vernier hook and point gauge range 0-150 mm. Software for data display and analysis by computer (separately supplied). (0 reviews)