Additional information
| Brand | Essom |
|---|
Cavitation Panel
This apparatus is for demonstrating the liquid vaporization under low pressure due to high flow velocity such as when water flows through a restriction in a pipe or a water passage. It is to be used with Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
The test section is a transparent Venturi for vapor observation. Pressure and vacuum gauges are connected to pressure tappings at the upstream end and throat respectively of the test section. The test section and the gauges are mounted on a panel. The panel is intended for use with a Hydraulics bench (separately supplied) or an outside water supply with sufficient pressure and flow rate.
TYPICAL EXPERIMENTS
- Demonstrations of cavitation
- Cavitation processes at different flow rates and pressures
TECHNICAL DATA
| Gauges | Pressure 1 ea. at inlet. | |
| Calibration weights | Vacuum 1 ea. at throat. | |
| Software for data display and analysis by computer (separately supplied). | ||
100% Original and qualityRelated products
-
Hydraulic Studies and AccessoriesPipe Friction
This equipment measures pressure drop when water flows through a vertical pipe at various flow rates both laminar and turbulent. It is to be used with Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
It consists of adjustable constant head water source of removable clear acrylic cylinder for laminar flow. Turbulent flow may be achieved by directly connecting the pipe to the Hydraulics Bench water supply. A water manometer with a vent valve, a hand air pump and a differential pressure gauge are provided for measurement of pressure drop. A valve at the outlet is used to control outlet pressure.
TYPICAL EXPERIMENTS- Investigations of laminar and turbulent flows
- Demonstration and measurement in a change of the laws of resistance (friction factor) from laminar to turbulent flow
TECHNICAL DATAWater manometer 450 mm x 1 mm graduation. Differential pressure gauge 1 ea. Test section length Over 500 mm. Measuring cup 1 L. Software for data display and analysis by computer (separately supplied) (0 reviews) -
Hydraulic Studies and AccessoriesFlow Through an Orifice
This flow study equipment allows measurement of contraction and velocity coefficients, as well as discharge coefficient for an orifice discharge. It is to be used with Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
It consists of a removable clear acrylic cylinder with adjustable constant head. Water is admitted to the cylinder via a discharge head. An adjustable overflow allows various constant heads for the test. An orifice is fitted at the bottom of the cylinder flush with the base plate. A traverse assembly is provided below the cylinder. Attached to this assembly is a wire and a pitot tube. The wire is to measure the jet diameter hence the vena contracta diameter and the pitot tube is to measure the jet velocity. The velocity head on pitot tube and total head due to tank water level are indicated on manometer tubes. The apparatus rests on adjustable footings and a bull’s eye level is provided.
TYPICAL EXPERIMENTS- Determination of contraction and velocity coefficients
- Calculation of discharge coefficient
- Study of the outlet jet (diameter, velocity)
TECHNICAL DATAStandard orifice 13 mm diameter, sharp edge Traverse travel 0.01 mm division Measuring cup 1 L Software for data display and analysis by computer (separately supplied). (0 reviews)