The Three Phase Separator with Wellhead Control (Model USPP-302)

Related products

• 

  • 
  • 

  Air Flow and Thermodynamics

  Training Boiler: 100kg/hr

  This is a set of steam boiler and standard accessories for a study of boiler performance.

  The basic unit consists of a small industrial type boiler with a burner, a feed water system, a fuel system, and instruments for monitoring boiler operation as well as instruments for control and safety. The complete unit is
  arranged as a package on a pallet for easy site installation. Optional equipment are available for additional experiments.

  Instruction manual is also included.

  TYPICAL EXPERIMENTS

  • Pressure, temperature and flow measurements.
  • Heat of combustion, heat given to steam and boiler efficiency.

  TECHNICAL DATA

  The boiler set consists of:

  Boiler unit:
  – Type	Vertical, water tube
  – Rated output	Approx. 105 kW (90,300 kcal/h)
  – Equivalent evaporation	Approx. 100 kg/h steam
  – Maximum working pressure	10 kg/cm2 (0.98 MPa)
  – Measuring instruments	Pressure gauge for steam outlet , Temperature sensor and indicator with a selector switch for or feed water, outlet steam and exhaust stack
  – Safety devices	Safety valve , Low level alarm
  – Boiler accessories	Steam pressure regulator , Steam separator , Feed water pump , Stack, 2x 2.4 m stainless steel with elbows

   

  Burner:
  – Type	Forced draft, pressure atomized
  – Control	On-Off
  – Fuel	Diesel or kerosene (LPG is available as an option.)
  Fuel system	Fuel tank, fuel meter and oil strainer
  Feed water system	Resin filter, soft water tank and water meter.
  Power supply	220V, 1 Ph, 50Hz. Other power supply is available on request.

  (0 reviews)
• 

  Process Control

  Liquid & Gas Absorption Process Pilot Plant (Model PP-101)

  The Liquid & Gas Absorption Process Pilot Plant (Model PP-101) is connected and fully monitored from an industrial Programmable Logic Controller (PLC), with a SCADA system mounted on a local control panel. The PP-101 is designed with an option to be connected to any industrial standard DCS control system via the “Selector” switch at the local panel.
  It consists of the following minimum equipment and instrumentation:

  • • Pre-fabricated scaled-down stainless steel platform, with pre-installed stainless steel piping, stainless steel water separation unit, air compressor, instruments and instruments support accessories, valves, etc.
    • Industrial standard analytical sensors and transmitters. Transmitters come with tubing and support accessories in a modular basis for easy hook-up to the plant.
    • Local control panel installed with electrical starter for motor, power supply (240VAC & 24VDC), switches, pushbuttons, indicators, SCADA system and other connections accessories.
    • Raw materials for experiments.
    • Industrial standard mass flow meter with pre-installed piping and tubing in a modular basis for easy hook-up to the plant. Gas analyzer with pre-installed piping and tubing in a modular basis for easy hook-up to the plant.
    • Moisture production unit to inject moisture into the gas pip
    • Two (2) moisture separator units to remove moisture from gas.
    • CO2 removal unit to remove CO2 content in gas.
    • Other calibration tools for sensor and transmitter calibration.

  (0 reviews)