Additional information
| Brand | Essom |
|---|
Mini Axial Flow Propeller Turbine
This equipment demonstrates axial flow propeller turbine characteristics i.e. torque, power and efficiency at different speeds for various heads and flow rates of water. It is to be used with a submersible pump and an Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
The turbine fixed guide vanes direct water helically to the runner. Inlet-pressure is indicated by a manometer. Torque is measured by a Prony brake with two spring balances. Speed is indicated on a portable tachometer. Flow rate is measured by the Hydraulics Bench measuring tank.
TYPICAL EXPERIMENTS
- Efficiency of Axial flow propeller turbine
- Characteristic of Axial flow propeller turbine
- Turbine torque and power output versus speed and flow rate at various heads.
TECHNICAL DATA
| Construction | Stainless steel casing with transparent . guide vane and runner section | |
| Maximum power | 10 W | |
| Submersible pump | 0.37 kW | |
| Measuring instruments | ||
| – Torque | Spring balances | |
| – Speed | Portable tachometer | |
| Software for data display and analysis by computer (separately supplied). | ||
100% Original and qualityRelated products
-
Hydraulic Studies and AccessoriesFree and Forced Vortex: Rotating Paddle
This equipment is designed to produce and measure free and forced vortices. It is to be used with Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
The equipment consists of a clear acrylic cylinder on a plinth. The free vortex is generated by water discharging
through an interchangeable orifice at the base of the cylinder and the resulting profile is measured by a combined caliper and depth scale. The forced vortex is generated by a paddle at the base of the cylinder which is rotated by jets of water, and the profile is measured by a series of depth gauges. The velocity at any point in the free and forced vortices may be measured using a pitot tube.TYPICAL EXPERIMENTS- Determination of the surface profile of a free and forced vortices Determination of velocity
- Determination of velocity
TECHNICAL DATAOrifice diameters 4 different sizes Distance from center of depth probes 0 to 110 mm. Pitot tube measuring points 3 different radius. Software for data display and analysis by computer (separately supplied). (0 reviews) -
Hydraulic Studies and AccessoriesBends and Fittings Friction
The equipment measures pressure drops at various flow rates when water flow through different pipe bends, and fittings. It is to be used with Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
All bends and fittings are connected in series with pressure tappings on both sides of each device. A water manometer with a vent valve and a hand air pump is connected to these tappings. A valve at the outlet is used to control outlet pressure.
TYPICAL EXPERIMENTS- Determination of Pressure Drop across various pipes and fittings at differing flow rates.
- Estimation of Loss Coefficient (K) or various pipes, pipe fittings and valve settings
TECHNICAL DATAPipe diameter (nominal) 20 mm. Enlarged pipe diameter (nominal) 35 mm. Bends 90º Miter bend , 90º small radius bend , 90º large radius bend Fittings 90º Elbow , 45º elbows , Sudden expansion , Sudden contraction Water manometer 8 tubes x 450 mm x 1 mm graduation Software for data display and analysis by computer (separately supplied). (0 reviews)