Additional information
| Brand | Essom |
|---|
Hydraulic Ram Pump
The apparatus demonstrates the principle of a ram pump. It is to be used with Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
Water from a Hydraulics Bench is supplied to a reservoir with an overflow pipe. Height of the reservoir is adjustable. Water from the reservoir is supplied to the ram pump which has two valves. One valve allows the water to discharge in adjustable pulse controlled by a counter weight. When this valve shuts, the pressure wave will push the water in the pump via a check valve through a non-return valve to the delivery pipe. Water is delivered to a clear graduated cylinder with an adjustable height. A pulse chamber is provided to smoothen the ram delivery.
TYPICAL EXPERIMENTS
- Demonstration of the principle of a ramp pump
- Determination of efficiency of the Hydraulic Ram
TECHNICAL DATA
| Pump material | Stainless steel | |
| Graduated cylinder | 1 ea. | |
| Adjustable supply head | Up to 1000 mm | |
| Adjustable delivery head | Up to 2000 mm | |
| Software for data display and analysis by computer (separately supplied). | ||
100% Original and qualityRelated products
-
Hydraulic Studies and AccessoriesHydrostatics Pressures
This equipment allows the moment caused by a fluid thrust on a wholly or partially submerged plane surface to be measured directly.
A PVC quadrant is mounted on a balance arm pivoted on knife edges which coincide with the quadrant center. When the quadrant immerses in water, there are hydrostatic forces. The balance arm has an adjustable counter balance and weights with a hanger. The quadrant is mounted on top of a clear acrylic tank which allows water to be admitted and drained to a required level by a valve. The tank rests on adjustable footings and a bull’s eye level is provided.
TYPICAL EXPERIMENTS- Visual demonstration of the Shear Force and Bending Moment at a cut section in a beam
- Determination of the Centre of Pressure
TECHNICAL DATAQuadrant Inner radius 100 mm Outer radius 200 mm Width 75 mm Weights 1 lot. Software for data display and analysis by computer (separately supplied). (0 reviews) -
Hydraulic Studies and AccessoriesFlow Over a Notch
The apparatus is for the study of flow over a notched weir. It is to be used with Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
Three weir plates, a rectangular notch and two V notches, are provided. Characteristics of flow over the notches can be observed and coefficients of discharge can be determined. The plates are attached to the open channel of the Hydraulics Bench. Water is supplied to the channel via a discharge diffuser and passes through a stilling baffle to smooth the flow. A vernier hook and point gauge is provided to measure the height of water level in the channel.
TYPICAL EXPERIMENTS- Investigation of head against discharge
- Coefficient of discharge for notches
- Demonstration of flow over different notch weirs
TECHNICAL DATAWeir plates Rectangular notch, 60o and 90o V notches. Stainless steel vernier hook and point gauge range 0-150 mm. Software for data display and analysis by computer (separately supplied). (0 reviews)