Additional information
| Brand | Essom |
|---|
Centrifugal Pump Test Set
This is a self-contained set for studying the centrifugal pump characteristics at various speeds.
The unit consists of a storage tank, a centrifugal pump with a motor, an advanced inverter, and other measuring instruments. The unit is on wheels
Instruction manual is also included.
TYPICAL EXPERIMENTS
- Flow rate vs head at various speeds.
- Pump input, output, and true efficiency at various speeds.
TECHNICAL DATA
| Pump ratings | |
| – Maximum flow rate | 150 Lpm |
| – Maximum head | 30 m water |
| Speed control | Advanced inverter |
| Measuring instruments | |
| – Flow rate | Water meter and stop watch |
| – Pressures | Pressure gauges at pump suction and discharge |
| – Pump speed and motor input power | Advanced inverter |
| Software for data display and analysis by computer (separately supplied). | |
| Power supply | 220 V, 1 Ph, 50 Hz. Other power supply is available on request. |
100% Original and qualityRelated products
-
Hydraulic Studies and AccessoriesBernoulli’s Theorem Apparatus
Bernoulli’s theorem is applied on flow through a clear acrylic Venturi tube. The apparatus is to be used with Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
Static pressures at various points along the wall of a transparent Venturi tub are directly measured on a manometer equipped with a vent valve and a hand air pump. A movable stainless steel total head probe is also provided. Flow through the Venturi tube is controlled by a valve at the outlet. As a primary flow measuring device, coefficient of discharge for the Venturi tube can also be determined.
TYPICAL EXPERIMENTS- Application of the Bernoulli equation
- Measurement of the meter coefficient of discharge at various flow rates
- Comparison of experimental results with theoretical predictions
TECHNICAL DATADiameters 28 mm inlet. Taper Upstream 21°, Downstream 10° Water manometer 8 tubes. Total head probe 1 ea. Software for data display and analysis by computer (separately supplied). (0 reviews) -
Hydraulic Studies and AccessoriesHydrostatics Pressure – Tilting Submerged Quadrant
This equipment allows the moment caused by a fluid thrust on a wholly or partially submerged plane surface to be measured directly. This surface can be tilted.
A PVC quadrant is hinged on a shaft pivoted on knife edges which coincide with the quadrant center. The quadrant position is adjustable relative to a balance arm such that the submerged plane surface can be tilted by changing the lock pin position. A depth scale is indicated on the quadrant. When the quadrant is immersed in water, there are hydrostatic forces.
The balance arm has an adjustable counter balance and weights with a hanger. The quadrant is mounted on top of a clear acrylic tank which allows water to be admitted and drained to required level by a valve. The tank rests on adjustable footings and a bull’s eye level is provided.
TYPICAL EXPERIMENTS- Visual demonstration of the Shear Force and Bending Moment at a cut section in a beam
- Determination of the Centre of Pressure
TECHNICAL DATAQuadrant Inner radius 100 mm – Outer radius 1 lot. – Width 75 mm Tilting angle 0 to 30 degrees in either direction. Weights 1 lot. Software for data display and analysis by computer (separately supplied). (0 reviews)