Additional information
| Brand | Essom |
|---|
HF 508 TILTING FLOW CHANNEL, 75 mm. wide
This is a bench top, self contained open channel designed for studying flow phenomena. It is a service unit to be used with optional accessories and models below.
The channel is of rectangular cross section supported by a steel frame. Side walls are transparent to allow full visual observation. Tilting can be adjusted by a manual screw jack. A stainless-steel head tank with a stilling baffle provides a smooth flow and water is returned to the storage tank.
Instruction manual is also included.
TYPICAL EXPERIMENTS
- Flow measurement.
- Hydraulic jump.
- Continuity and energy equations.
- Discharge under sluice gate.
TECHNICAL DATA
| Channel size | 75 mm wide, 250 mm high and 2.5 m long | |
| Tilting adjustment | -2% to + 5% | |
| Side walls | 8 mm Clear acrylic with clear vertical scale | |
| Channel bed | Stainless steel | |
| Flow measurement | Water meter and stop watch | |
| Software for data display and analysis by computer (separately supplied). | ||
| Power supply | 220 V 1 Ph 50 Hz. Other power supply is available on request. | |
100% Original and qualityRelated products
-
Hydraulic Studies and AccessoriesBernoulli’s Theorem Apparatus
Bernoulli’s theorem is applied on flow through a clear acrylic Venturi tube. The apparatus is to be used with Hydraulics Bench i.e. HB100 or HB100N (separately supplied).
Static pressures at various points along the wall of a transparent Venturi tub are directly measured on a manometer equipped with a vent valve and a hand air pump. A movable stainless steel total head probe is also provided. Flow through the Venturi tube is controlled by a valve at the outlet. As a primary flow measuring device, coefficient of discharge for the Venturi tube can also be determined.
TYPICAL EXPERIMENTS- Application of the Bernoulli equation
- Measurement of the meter coefficient of discharge at various flow rates
- Comparison of experimental results with theoretical predictions
TECHNICAL DATADiameters 28 mm inlet. Taper Upstream 21°, Downstream 10° Water manometer 8 tubes. Total head probe 1 ea. Software for data display and analysis by computer (separately supplied). (0 reviews) -
Hydraulic Studies and AccessoriesMetacentric Height
This equipment is designed to determine the metacentric height of a floating body and the height variation with the tilt angle. It is to be used with Hydraulics Bench i.e. HB100 or HB100N or a bowl (separately supplied).
The equipment consists of a rectangular pontoon. The center of gravity of the pontoon can be moved sideways by moving horizontal jockey weight.
The angle of tilt of the pontoon is indicated by a plumb-bob on a scale attached. The center of gravity of the pontoon can also be moved vertically by means of adjustable vertical weights on the mast.
TYPICAL EXPERIMENTS- Experiment to illustrate the floatation characteristics
- Determination of the Metacentric Height
TECHNICAL DATAPontoon 400 mm long x 200 mm wide x 100 mm high. Horizontal scale 1 mm graduation. Maximum angle of tilt ± 13ox 0.5º graduation Vertical sliding weight 1 ea. Jockey weight 1 ea. Software for data display and analysis by computer (separately supplied). (0 reviews)